Stabilizer Technical Datasheet 1.Make:Industrial Electrical Corporation2.Rating in Amp.:1 to 1500 kVA , 3/1 Phase, Balance / Unbalance type.
3.Input Voltage Range:170 -270 V / 150 - 270 V for 1 phase ( can also provide min. range 120 V and max. range 300 V ) 360-480 V / 330 - 480 V / 300 - 480 V for 3 phase ( can also provide min. range 250 V and max. range 500 V )
4.Input Frequency Range:50 Hz.5.Output Voltage Range:220 / 230 /240 V +/- 1 %, adjustable 5 % for 1 phase 380 / 400 / 415 V +/- 1 %, adjustable 5 % for 3 phase
6.Output Freq. Range 50 Hz.7.Type of Installation:Indoor./ outdoor8.Type of Cooling:Air cooled / Oil cooled. ( without oil )9.Qty. of Oil:Depends on rating of stabilizer.10.Oil Type:Transformer oil as per IS 335.11.No. of parts of Stab:1 No.12.Temp. rise:45 C Maximum More than Atmosphere temp. (as per IS specification)
13.Correction Rate (V/Sec.):Max. 32 Volt / Sec.14.Wave Form Distortion:Nil15.Duty Cycle:100 % or S116.Mounting:Floor mounted / Free on wheel17.Metering:voltmeter with selector switch Ameter with selector switch ( customer request )
18.Indicating Lamps:Power On , High / Low voltage Indication,
19.Protection ( on request ):A) Over Load Protection B) Over / Under Voltage cut off C) single phasing preventor D) short circuit protection20.Bypass Facility:on request of customer21.No load losses:1 % of the rated VA22.Load losses at full load:3 % of the rated VA23.Efficiency at 50 % load:More than 98.5 %24.Efficiency at 80 % load:More than 98 %25.Efficiency at full load:More than 97 %26.Regulation:+/- 1 %27.Life of roller carbon brush:Min.5 Yrs. Roller Carbon with min wear & tear. Angular Pressure Roller Carbon Brush Assembly Which will protect the winding wire from Vertical Pressure deformation. ( roller carbon brush above 40 Amp.)
28.Construction:MS sheet with square pipe for air cooled / Bottom part is with oil tank and above portion are framing with angle structure and covered with fabricated sheet with gasket for oil cooled.
29.Size of the unit:Depends on rating of stabilizer.